Important! Pacific Power's planned changes to the incentives and equipment qualifications associated with our energy efficiency program will become effective January 1, 2014. On September 20, 2013 the program retired incentives for CFLs in new homes. For questions or additional clarification, please email HES@pacificpower.net.
Cut hot water heating costs with an energy-efficient electric storage water heater.
After heating and cooling, water heating is the biggest use of energy in your home. From hot showers to dishwashing, a typical household spends an average of $400 per year on heating water! By installing a more energy-efficient electric storage water heater, you can cut that cost without cutting out daily showers.
Storage water heaters – the most common type – work by heating up water in an insulated tank. Heat is lost through the walls of the storage tank (standby heat loss), consuming energy even when you're not using hot water. New energy-efficient storage water heaters have higher levels of insulation around the tank, substantially reducing standby heat loss and saving you money. Because water heaters can fail with minimal warning, leaving you little time to research energy efficiency options, plan ahead and be prepared.
- Incentive Application
- Solicitud de Incentivo (Spanish version)
- Qualified Water Heaters
- Eligible Customers
Energy Saving Benefits
- Reduce standby heat loss to save money on your electricity bill
- Average annual savings on your electricity bill combined with the available incentive offsets the cost to upgrade to a high-efficiency model within first year
- Use less energy and avoid greenhouse gas emissions
- Reduce your home's carbon footprint
QualificationsElectric storage water heater
$75 customer incentive
$50 contractor incentive for electric water heaters installed by a Program Participating Plumber or Electric Water Heater Installer
- 40 – 49 gallon capacity with an Energy Factor, or EF, of 0.94 or greater
- 50 – 65 gallon capacity with an EF of 0.95 or greater
- 66+ gallon capacity with an EF of 0.93 or greater
- Unit must be on the Qualified Water Heaters list at time of purchase
- Incentive Application must be postmarked within 90 days of purchase
- Electric water heater should be installed according to manufacturer installation instructions
- Itemized invoice showing separate electric water heater equipment and installation costs must be submitted with incentive application when installed by a Program Participating Plumber or Electric Water Heater Installer
- First, read the label to see if it gives indication.
- If you can't figure it out from the label, take a look at the pipes.
- Gas water heaters will have 3 pipes: gas in, water in and water out. The gas line, often at the bottom of the unit, will have a shut-off valve on it. This differentiates it from an electrical conduit.
- Electric water heaters will have 2 pipes: water in and water out with an electrical conduit or electrical wire feed line.
Please note: Gas lines and electric wiring can be extremely dangerous. Be sure to contact a plumbing professional if you're unable to discern the type of water heating system in your home.
Please see Incentive Application for a list of required documentation and additional terms and conditions. Incentives are subject to Washington Utilities and Transportation Commission approval and may change with 45 days notice. Additional terms and conditions may apply.